40oz Tumbler Gloss Stainless Steel Sublimation Blank – Pink Trims

📝 Preparation

1. For templates, mock-ups and image size requirements, please refer to the Design tab.
2. Print your design and mirror your image.
3. Clean the substrate printing surface using a microfibre cloth or lint brush to remove dust, oils or lint.
4. Place the printed image face up and align the substrate to the centre of the print.
5. Secure the edges using heat-resistant tape to prevent movement.

🛠️ Oven/Air Fryer Baking

1. Heat the oven to the required temperature.
2. Apply heat shrink, heat tape or a suitable silicone clamp.
3. Place the substrate inside the oven.
4. Bake at the listed heat settings.
5. In some air fryers, you may need to rotate halfway through baking due to insufficient air flow.
6. Remove carefully from the oven after the timer has finished. The item will be extremely hot.

❄️ Cooling and Assembly

1. Remove adhesive cover from tumbler base and apply to the centre of the substrate. (If applicable)
2. Attach lid.
3. Re-Attach handle using screwdriver.
4. Wrap in protective plastic cover and place into packaging.

✅ Tips for Best Results

• Screw lid on and pay attention the where the straw will be located, align the main focus point of the print to the this area.
• When taping the seam, tape with high pressure applied to the print ensuring tightness.
• Do not press with handle, lid or base attached.
• Trim heat shrink to not have too much excess overhanging, it is hard to remove.