Onesie Pink Polyester Sublimation Blank – XXL

📝 Preparation

1. For templates, mock-ups and image size requirements, please refer to the Design tab.
2. Print your design and mirror your image.
3. Clean the substrate printing surface using a microfibre cloth or lint brush to remove dust, oils or lint.
4. Place the substrate with the coated / printable side facing up.
5. Secure the edges using heat-resistant tape to prevent movement.

🛠️ Flat Heat Press Pressing

1. Set the heat press to the listed flat press settings.
2. Place a sheet of protective paper on the press.
3. Position the substrate and transfer correctly on the press.
4. Cover with another sheet of protective paper.
5. Press at the listed settings.
6. Remove carefully when the timer has finished. The item will be hot.

❄️ Cooling and Assembly

1. Carefully remove the substrate from the press (it will be hot).
2. Peel off the sublimation paper while the substrate is warm for best results.
3. Allow the substrate to cool completely.
4. Attach or reassemble any internal mechanisms, lids or parts if applicable.

✅ Tips for Best Results

• Ensure full edge-to-edge coverage in your design to avoid white borders (ensure bleed is sufficient).
• If colours look dull, increase time by 5 seconds or pressure slightly.
• If the coating looks yellowed, your temperature is too high or time too long.
• Store substrate in a clean, dry, dust-free area before printing.
• If you use a pressing pillow that is greater than the size of the image and the paper is larger than the pressing pillow, you will not get any paper border lines.
• If you see small black marks, this is burnt lint (pay more attention to lint brushing).
• Being a non white substrate colours will not look as vibrant, usually logos and patterns in black work well.
• If you do not use a pressing pillow imagery can transfer through to the other side of the substrate.